Hasselblad H6D-50C - Light Meter Exposure Mode

H6D www.hasselblad.com
USER GUIDE
To Use
85
LIGHT METER EXPOSURE MODE
The Light Meter Exposure Mode can be changed on the
Control Screen or by pressing the EXP button on the
Viewnder. Use the Rear Scroll Wheel to select Mode.
Different Light Metering Modes
There are three reective metering modes available.
Centre Weighted, Centre Spot and Spot metering.
Exposure Spot Mode
In Camera Settings / Exposure Mode you can select the
Spot Mode to be
- Normal Mode.
- Zone Mode.
Centre Weighted
Used for light situations where there is no
particular dominance of light or dark areas
across the tonal range. Takes into account
approximately 25% of the image seen in the
viewnder.
Centre Spot
Emphasizes the central section of the focusing screen
equivalent to approximately 25% of the image. This
provides a balanced assessment and is a typical
choice where the main subject is in the centre.
Spot
The sensitive area is equivalent to approximately
2.5% of the image area (the central spot on the
viewnder screen). Any parts of the image outside of
this area will not affect the exposure reading. This
provides a very accurate measurement of specic
tones. Typically used in the zone system and similar
light measuring situations where maximum control
is required. Also excellent for tonal comparison
measurements. The spot mode can display zones
instead of EV's in the viewnder display.
Light Metering ModesSymbol Light Metering Distribution
Centre Weighted
Centre Spot
Spot
METER METHOD
Exposure Modes
Sensor Unit Display.
Exposure Settings Menu
Increment Step Size
Exposure Mode
CAMERA SETTINGS: EXPOSURE
Exposure:
Exposure Adjust:
Spot Mode:
True Exposure:
1/2 step
1/3 step
Normal