Hasselblad H6D-50C - Access to Flash Controls

ACCESS TO FLASH CONTROLS
1 Activate the camera and press the +/ - button on the
Viewnder once.
2 Turn the Front Scroll Wheel (A) to set the amount of
compensation required from +3 EV through -3 EV.
3 To set whether the ash is triggered just after the shutter
opens or just before the shutter closes go to Camera
Settings > Exposure > Flash and set Sync to Normal or Rear.
4 To set Flash Measure, program a button in Camera Settings
> Custom Buttons to Flash Measure. Then trigger Flash
Measure using this button.
5 When set to Flash Measure, a specic screen on the Grip
Display requests you to press the AE-L button in order to
make a reading.
H6D www.hasselblad.com
USER GUIDE
To Use
91
Grip Display Settings
Flash compensation
set to +1.0, Front Scroll
Wheel (A) and exposure
compensation set to -0.7,
Rear Scroll Wheel (B).
Grip Display View
Flash compensation
set to +1.0, Front Scroll
Wheel (A) and exposure
compensation set to +1.0,
Rear Scroll Wheel (B).
A
B
A Front Scroll Wheel
B Rear Scroll Wheel