Hasselblad H6D-50C - Remove and Attach the Viewfinder

3.20 REMOVE AND ATTACH THE VIEWFINDER
How to remove the Viewnder
1 Hold the viewnder steady.
2 Press the viewnder release button (A).
3 Lift the rear of the viewnder up and away from the camera
body (B).
How to attach the Viewnder
1 Hold the viewnder at a slight angle and rest it on the top of
the camera.
2 Slide the viewnder forward until the front locating pin is
in position in the recess in the front edge of the viewnder
screen aperture on camera body.
3 Press the rear part of the viewnder rmly downwards until it
clicks into place.
4 Ensure that both sides of the viewnder are seated correctly
and that it has been rmly attached and locked into position.
Warning!
Failure to do so could cause an intermittent malfunction
if the data bus interface connections between the viewnder
and camera body are not positively secured.
Note!
Do not lift or hold the camera by the viewnder alone.
A
B
H6D www.hasselblad.com
USER GUIDE
Overview
41