haTmed Q70B - Connection Requirements

- 9 -
2.4 Connectionrequirements
2.4.1 Electricalconnections

 220V/50Hzpowersupply.Themaximumpowersupply
fluctuationrangeis198V~242V.
 Useaseparate16Apowercircuit.Provides30mAleakage
protection.
 Makesurethepowercableisnotknottedorpressed.
 Donotuseforcetopullthepowercable,
 Donotplacethepowercablenearaheatsource.
 Donottouchthepowercablewithasharpobject.
 Donotreplacethepowercableorpowerplug.Donotusea
damagedpowercableorpowerplug
 Do not use this device if the power cable or power plug is
damaged.Thepowercableorpowerplugmustbereplacedbya
professionalauthorizedbythemanufacturerofthisdevice.

2.4.2 Distilledwaterinjection
OpenupcoveroftheinternalwatertankandInjectthedistilledwaterintotheinternalwatertankthroughthe
watertank deflector,pleasebenotedthatthedistilledwateraddedshouldnotexceedtheheightofthewater
deflector,generallystoredinastandard12Ldistilledwatertank.Fulltankofdistilledwatercancompleteupto20
sterilizations.Please pay attention totheamountofdistilledwaterremaininginthetanktoavoidaffectingthe
normaloperationofthisdevice.


 Compliance with YY/T 0646‐2015 high quality distilled water as
specifiedinappendixBordemineralizedwaterbecausethedegree
offormationofruststainsdependsonwhetherthewaterqualityof
thedistilledwaterisuptostandard.
 Conductivity≤20μs/cm；
 Iftheinletpressureis>30Kpamaycauseexcessdistilledwaterto
enterthechamberandaffecttheoperationofthedevice.
 Inordertopreventthedistilledwaterfrombeingcontaminated,the
lidofthedistilledwatertankmustbetightenedortightatalltimes.
 Forsmallsteamsterilizerwithinternalwatertank,pleasedrainthe
wastewatertankbeforeinjectingdistilledwater.
 Regularlycleanthedistilledwatertankatleastonceamonth.