24
Enter/Exit Service (or Service—Timed) Mode
1. Go to Aqua Logic main unit (normally mounted near the pool equipment)
2. Pressing the “Service” button rotates through normal operation (red LED off), service mode
(red LED on continuously) and service-timed mode (red LED flashing).
Note: This operation can only be performed at the main Aqua Logic unit. Both “Ser-
vice” and “Service-Timed” disable all automatic programmed operations and allow
manual operation from the main unit only. The buttons on the remote display/keypads
will still be able to turn equipment off in case of an emergency, but will not turn any
equipment on. If the system is in “Serviced-Timed” it will automatically switch back to
normal operation at the end of the 3 hour time period.
To Next Page
Loading...
Need help?
General
