USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
21
Diagnostic Menu
1.
2.
3.
4.
5.
6.
NOTE: For troubleshooting purposes, the Event Log will record the last twenty error/trip conditions and/or status messages, as well as the amount of time that
has elapsed since the condition occurred. See page 26 for more detail.
Stop/Resume
1.
2.
NOTE: When Stop/Resume is pressed at any time during normal operation, the above message will be displayed. The pump will stop within several seconds, and
will remain stopped until Stop/Resume is pressed a second time, at which point the pump will resume normal operation.
Quick Clean
1.
2.
Screen
Quick Clean
Quick Clean running
Quick Clean
3450 rpm for 60 min;
Screen
Pump is stopped;
press Stop/Resume
again to resume
normal operation
Use > button to enter Diagnostic Menu and toggle between displays.
Displays firmware version of the display PCB.
Screen Buttons Used Comments
Diagnostic Menu
Press > to enter
Press > to
view next item
Display Revision
2.00
Drive Serial Number
3581200032
Comm Rev: 10.10
Drv Rev: 2.00.65
Displays motor drive serial number.
Displays firmware revisions of the motor drive and drive interface PCBs.
< >
Event Log
Press > to view
Use > button to view event log.
< >
To Next Page
Loading...
Need help?
General
