6 Using the heating system – Heating up the system
58
25.Lay some small pieces of cardboard in front of the igniter gun (2)
on the wood inside the fuel chamber (3).
26.Fill up the fuel chamber (3) with fuel.
27.Close the fuel chamber door (1).
28.The message Fill fuel chamber and confirm ignition is displayed.
29.Confirm your input by pressing the Confirm button (1).
✓ The Close doors message appears in the display.
30.Make sure that all of the doors are closed.
31.Wait until the progress bar is full.
✓ The Underpressure test message appears in the display.
32.Wait until the progress bar is full.
Only put in as much wood as the heating system and accumulator
can absorb as energy.
Figure 6/15 - Filling the fuel chamber and confirming ignition
Figure 6/16 - Closing the doors
Figure 6/17 - Underpressure test
To Next Page
Loading...