Heatmiser Wireless Series - Pairing with the UH8-RF V2 Wiring Centre; UH8-RF V2 Pairing Steps

11
Wireless Series
Pairing Menu Explained
Feature P1 - Pairing: to the RF-Switch V1 & V2, RF-Switch 16 Amp & UH8-RF V2.
Feature P2 - Setting the UH8-RF address: This is the number set on the rotary
dials inside the UH8-RF unit, the zone number & zone type.
Feature P3 - Failsafe: If the receiver fails to receive a signal from the
Slimline-RF V3 within a 40 minute period, it will activate the output for
12 minutes every hour. The receiver will continue to do this until it receives a
signal from the Slimline-RF V3.
Pairing Menu
P1
P2
P3
FEATURE
DESCRIPTION
Commences countdown from
99 – 00 seconds.
00 – 99 = Receiver address/zone no. & type.
00 = Disabled 01 = Enabled (Default)
SETTING
Pairing to RF-Switch 1&2
& UH8-RF V2
Pairing to UH8-RF
Failsafe
• Turn Off the thermostat by, holding down the Power button for 3 seconds.................
• Now hold down the H button for 3 seconds unit you see P1 in the top right hand
corner of the display..........................................................................................................................
• Repeatedly press Clock to select the desired P1, P2 or P3 setup pages.........................