Heatmiser Wireless Series - LCD Display

16
Model: Slimline-RF V3
Pairing With the RF-Switch 16 Amp
Step 1, On the RF-Switch 16 Amp:
• Press and hold the Pair button for 5 seconds, the Pair light will start flashing and pairing
mode is now active on the RF-Switch.
Once the RF-Switch detects the pairing signal from the Slimline-RF V3, the Pair light will turn off.
Step 2, On the Slimline-RF V3
• Turn Off the thermostat by, holding down the Power button for 3 seconds...........
• Now hold down the H button for 3 seconds unit you see P1 in the top right hand
corner of the display....................................................................................................................
• Tap H button once while P1 is shown to start a 99 second countdown...................
• During the countdown the thermostat will transmit a signal and flash the RF
icon at the top left hand corner of the display....................................................................
If pairing is successful, the countdown will jump straight to 00 followed by a blank
screen.
• Press the Power button on the thermostat once to turn the unit back On..............
If pairing is unsuccessful, eliminate a possible signal issue by repositioning the thermostat
closer to the receiver and repeat the pairing process again.
Feature 10 Mode 02 not suitable for RF-Switch 16 Amp unit.