Heatmiser Wireless Series - Pairing With the RF-Switch 16 Amp; RF-Switch 16 Amp Pairing

15
Wireless Series
Pairing With the RF-Switch
Step 1, On the RF-Switch:
• Press and hold the CH1 button for 5 seconds, the CH1 light will start flashing and pairing
mode is now active on the RF-Switch.
Once the RF-Switch detects the pairing signal from the Slimline-RF V3, the CH1 light will turn off.
Step 2, On the Slimline-RF V3
• Turn Off the thermostat by, holding down the Power button for 3 seconds...........
• Now hold down the H button for 3 seconds unit you see P1 in the top right hand
corner of the display....................................................................................................................
• Tap H button once while P1 is shown to start a 99 second countdown...................
• During the countdown the thermostat will transmit a signal and flash the RF
icon at the top left hand corner of the display....................................................................
If pairing is successful, the countdown will jump straight to 00 followed by a blank
screen.
• Press the Power button on the thermostat once to turn the unit back On..............
If in mode 02, the hot water timer will automatically be paired to the HW channel.
If pairing is unsuccessful, eliminate a possible signal issue by repositioning the thermostat
closer to the receiver and repeat the pairing process again.