• Do not start the engine if natural gas or propan butan is leaking in surrounding.
• Do not use compressed starting liquids, their vapours are flammable.
Warning: Petrol and petrol vapours are highly flammable and explosive. Fire or
explosion could cause serious burns or death. Therefore keep following instructions:
WHILE REFUELLING
• Stop the engine and let it cool before removing fuel plug.
• Refuel tank in open space or in well ventilated area.
• Do not overfill fuel tank. Fill petrol at least half inch under filling opening to let space for fuel
expansion.
• Protect petrol against sparks, open flame, pilot-light, heat and other sources of ignition.
• Check fuel pipes, tank and plug and all connection if their are tight and have no cracks. In case
of defect change damaged parts.
WHILE STARTING ENGINE
• Check if spark plug, exhaust muffler, fuel tank plug and air filter are correctly assembled.
• Do not start engine if the spark plug is removed.
• If you spill fuel, wait till vapours of and then only start the engine.
• If the engine is overflooded, push the choke lever to position 0/OPEN/RUN and gas lever to
position FAST and turn the engine till starts.
WHILE OPERATING THE MACHINE
• Do not tilt the engine and machine so that fuel can leak.
• Do not stop the engine by colsing carburetor.
WHILE TRANSPORTING THE MACHINE
• Transport the machine with empty fuel tank or closed fuel cock.
STORING PETROL OR MACHINE WITH PETROL IN THE TANK
• Store separately from ovens, stoves, water heater or other devices with pilot lights, or other
sources of ignition – they could ignite petrol vapours.
Warning: Rotating parts parts could catch hands, feet, hair, cloths or equipment. It
can result in serious lacerated wounds or even amputation.
• Work with the device with all protection devices duly assembled.
• Keep hands and feet in safety distance from rotating parts.
• Cover long hair and remove jewellery.
• Do not wear lose cloths, floppy cords etc.
Warning: Quick pull (kickback) of starting cord pulls in the hand and arm quicker
than you manage to unhand it. Danger of fracture, raw or tendon injury.
• While starting pull the cord slowly till you feel resistance. Only then pull strongly.
• Before starting remove all load for the engine.
• Firmly connected parts as knives, flywheels, belt wheels, teeth wheels etc. must be safely
fastened.(they move while starting).
To Next Page
Loading...
