EasyManua.ls Logo

hecht 8616 SE - Engine Oil

hecht 8616 SE
152 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
made for garden
27 / 152
PL
SK
DE
EN
CS
Never use stale or contaminated gasoline or oil/gasoline mixture. Avoid getting dirt or water in
the fuel tank.
WARNING! Petrol is highly flammable.
Store fuel in containers specifically designed for this purpose. Refuel outdoors only, before
starting the engine and do not smoke while refueling or handling fuel. Never remove the cap
of the fuel tank or add petrol while the engine is running or when the engine is hot. If petrol is
spilled, do not attempt to start the engine but move the machine away from the area of spillage
and avoid creating any source of ignition until petrol vapors have dissipated. Replace all fuel
tanks and container caps securely. Before tipping the machine (to maintain or drain oil) remove
fuel from tank.
WARNING: never fill fuel tank indoors, never with engine running or until the
engine has been allowed to cool for at least 15 minutes after running. Do not use
fuel which is older then 14 days. Old fuel in the fuel tank is the leading cause of
carburetor damage.
ADDING FUEL
1. Remove the fuel tank cap. (fig. 17A).
2. Fill the fuel tank to no more than 1 cm below bottom of filler neck.
Do not overfill. Wipe up spilled fuel before starting the engine.
ENGINE OIL
NOTE: This engine is delivered without oil, be sure to put oil in the engine before
the starting. Use only the recommended types of oil.
RECOMMENDED OIL
Use 4-stroke motor oil that meets or exceeds the requirements for API service classification SH,
SJ, or equivalent. Always check the API service label on the oil container to be sure it includes the
letters SH, SJ, or equivalent.
Recommended oil CASTROL Magnatec 5W-40 C3.
SAE 10W-40 is recommended for general use.
OIL LEVEL CHECK
CAUTION: Only check oil level with cold engine.
1. Place engine level. Check the oil level with the engine stopped and cooled down.
2. Remove the oil filler cap/dipstick (fig. 18A) a and wipe it clean.
3. Insert the oil filler cap/dipstick into the oil filler neck, but do not screw it in, then remove it
to check the oil level.
4. If the oil level is near or below the lower limit mark on the dipstick, remove the oil filler cap/
dipstick, and fill with the recommended oil (we recommend CASTROL Magnatec 5W-40 C3)
into the engine between the upper and lower mark. Do not overfill.
5. Reinstall the oil filler cap/dipstick.
Recommended oil / Empfohlenes Öl / Doporučený olej /
Odporúčaný olej / Zalecany olej
CASTROL MAGNATEC 5W-40 C3

Table of Contents

Other manuals for hecht 8616 SE

Related product manuals