SWEEPER
Problem Probable cause Corrective action
Sweeping brush not
working
Sweeping brush blocked with
foreign items
Set the Bowden cable
Bowden cable set too freely
Remove foreign items and check
whether the sweeping
brush is not damaged
Sweeping depth too
small
Sweeping brush setting too
small
Set the sweeping brush
Worn-out brushes Replace the brushes
SNOW BLOWER
Problem Probable cause Corrective action
Auger does not rotate
Foreign matter blocking Clean
Shear pin broken Replace the broken pin
Auger drive belt slipping
Adjust the belt and adjust control
rope
Auger drive belt broken Replace the belt
Auger does not stop when
the lever is released
Auger drive belt is out of correct
position
Adjust the belt
Auger drive guide is out of correct
position
Adjust the guide
Snow thrower veers to one
side
Tire pressure not equal Adjust the tire pressure
Uneven tires Unify tires
Scraper blade or shoes uneven
adjusted
Adjust scraper blade and shoes
Inadequate or no ejection
Snow ejection unit blocked
Clean the snow ejection unit with
a solid object
Auger screw not turning Adjust loose clutch cable
Shearing bolts sheared Replace shear bolts
CAUTION! Faults which can not be rectified with the aid of this table may be
rectified by a authorized service centre.
SERVICE AND SPARE PARTS
• Have your petrol tool serviced by a qualified repair personnel using only identical replacement
parts. This will ensure that the safety of the petrol tool is maintained.
• Whether you need technical advice, repair, or genuine factory replacement parts, contact the
WERCO authorized service nearest you. Information on service locations, visit www.hecht.cz
• When ordering spare parts, please quote the part number, this can be found at www.hecht.cz
To Next Page
Loading...
