EasyManua.ls Logo

hecht 8616 SE - Before.starting; Refueling

hecht 8616 SE
152 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
made for garden
26 / 152
PL
SK
DE
EN
CS
ASSEMBLY OF SNOW BLOWER (OPTIONAL ACCESSORIES)
1. Screw out the wing nuts on both sides of the machine (fig. 8) and remove the working unit
with sweeper.
2. Connect the working unit with snow blower to the body of the machine (fig. 9). Make sure
the snow blower is well connected to the drive shaft (fig. 10).
3. Ensure the snow blower with the wing nuts (fig. 11).
4. Mount the snow chute as shown (fig. 12) and connect the lever to control chute (fig. 13).
ASSEMBLY OF BRUSH (SWEEPER)
1. Remove the working unit with snow blower (fig. 14).
2. Align the working unit with sweeper (fig. 15) and connect it to the body of the machine with
the wing nuts (fig. 16).
3. Make sure that the cardan joint of sweeper is well connected to the drive shaft and tighten
up.
BEFORE STARTING
For your safety, and to maximize the service life of your equipment, it is very important to take
a few moments to check the engine condition before operating Be sure to take care of any
problem you find, or have your servicing dealer to correct it before you operate the engine.
WARNING! Improper maintenance to this engine, or failure to correct a problem
before operation, can cause a malfunction in which you can be seriously hurt or
killed.
Always perform a preoperation inspection before each operation, and correct any
problem.
1. Fuel level
2. Oil level
3. Air cleaner
4. General inspection: Check for fluid leaks and loose or damaged parts
5. Check the equipment powered by this engine.
REFUELING
Use unleaded gasoline with a pump octane rating of 90 or higher. This engine is certified to
operate on unleaded gasoline. Unleaded gasoline produces fewer engine and spark plug deposits
and extends exhaust system life. The fuel must not be older than 14-days.
WARNING! Gasoline is highly flammable and explosive, and you can be burned or
seriously injured when refueling.
Stop engine and keep heat, sparks, and flame away.
Refuel only outdoors.
Wipe up spills immediately.
NOTE: Fuel can damage paint and some types of plastic. Be careful not to spill fuel
when filling your fuel tank. Damage caused by spilled fuel is not covered under the
Warranty.

Table of Contents

Other manuals for hecht 8616 SE

Related product manuals