Fig. 5: Acquisition window with live images
If your device is a SPECTRALIS HRA/HRA+OCT, press on
the touch panel to activate ART Mean.
If your device is a SPECTRALIS OCT, press and hold the button
on the joystick for approximately two seconds to activate ART
Mean.
ART Mean is activated. The small live images are displayed on the
bottom of the acquisition window (Fig. 5). The progression bar
increases as the ART Mean counts to 100 frames.
Images can be acquired before ART Mean reaches the
adjusted number of frames. Under certain circumstances, e.g.
nystagmus, ART Mean processing might fail. In these cases,
acquire images without ART Mean.
Watch the small live images for an even illumination.
Keep your hands on the device and readjust the camera as
needed.
Press either “Acquire” on the touch panel or press the button on
the joystick.
The image is acquired.
To acquire several images, press “Acquire” again.
Switch off ART Mean.
Click “Save images” in the menu bar.
If you have acquired multiple images and have not closed the
acquisition window for an extended period, click “Save images” to
free up memory in the image data buffer and to prevent data loss
in case of PC and/or hardware problems.
To switch off the camera, press
on the touch panel or click in
the acquisition window.
turns to .
Acquiring images
Quitting the examination
Acquiring Images
Acquiring Images
5
© Heidelberg Engineering GmbH, Article No. 230134-002 INT
26
To Next Page
Loading...
Need help?
General