HEIDENHAIN ITNC 530 - Safety

HEIDENHAIN iTNC 530 Programming Station 13
1.1 Introduction
211, Circular slot Q338
Q206
þ
–
þ
–
þ
–
þ
–
þ
–
–
–
220, Circular pattern Q301
Q365
þ
–
þ
–
–
–
–
–
–
–
–
–
221, Linear pattern Q301 þþ––––
232, Face milling – x x x x x x
240, Centering – x x x x x x
241, Single-fluted deep-hole drilling – x x x x x x
247, Datum setting – þ xxxxx
251, Rectangular pocket (complete) – x x x x x x
252, Circular pocket (complete) – x x x x x x
253, Slot (complete) – x x x x x x
254, Circular slot (complete) – x x x x x x
256, Rectangular stud (complete) – x x x x x x
257, Circular stud (complete) – x x x x x x
262, Thread milling - þ xxxxx
263, Thread milling/countersinking – þ xxxxx
264, Thread drilling/milling – þ xxxxx
265, Helical thread drilling/milling – þ xxxxx
267, Outside thread milling – þ xxxxx
270, Contour train data – x x x x x x
Cycle
Additional
parameters
TNC 426/ TNC 430, software version TNC 410
280 476 280 474 280 472 280 470 280 462 286 060