HEIDENHAIN ITNC 530 - Page 14

14
1.1 Introduction
Differences in machining cycles with respect to older software
versions of the iTNC 530
Meaning of the symbols used in the table:
– Parameter not available in this software version
þ Parameter or cycle available in this software version
x Cycle not available in this software version
Cycle
Additional
parameters
iTNC 530,
software version
340 422 340 420
22, Rough-out Q208
Q401
Q404
þ
–
–
–
–
–
205, Universal pecking Q379
Q253
þ
þ
–
–
208, Bore milling Q351 – –
240, Centering – x x
241, Single-fluted deep-hole
drilling
–xx
251, Rectangular pocket
(complete)
– þ x
252, Circular pocket
(complete)
– þ x
253, Slot (complete) – þ x
254, Circular slot (complete) – þ x
256, Slot (complete) – x x
257, Circular slot (complete) – x x
270, Contour train data – x x