HEIDENHAIN ITNC 530 - Page 23

HEIDENHAIN iTNC 530 Programming Station 23
1.1 Introduction
Differences in miscellaneous functions M concerning the TNC 4xx
Meaning of the symbols used in the table:
x Function not available in this software version
þ Function available in this software version
M function TNC 426/ TNC 430, software version TNC 410
280 476 280 474 280 472 280 470 280 462 286 060
Two miscellaneous functions can be
programmed in one NC block
þ xxxxþ
M01 þ xxxxþ
M104 þþxxxx
M128 þþþxxx
M129 þþþxxx
M130 þþþþxx
M134 þþþxxx
M135 þþþxxx
M136 þþxxxx
M137 þþxxxx
M138 þþxxxx
M140 þ xxxxx
M141 þ xxxxx
M142 þ xxxxx
M143 þ xxxxx
M144 þ xxxxx
M145 þ xxxxx