HEIDENHAIN ITNC 530 - HELP Key

HEIDENHAIN iTNC 530 Programming Station 25
1.1 Introduction
Differences in Q parameter programming concerning older
software versions of the iTNC 530
Meaning of the symbols used in the table:
Differences in other functions concerning the TNC 4xx
Meaning of the symbols used in the table:
x Function not available in this software version
þ Function available in this software version
Function
iTNC 530, software
version
340 422 340 420
String formula QS... xx
Local parameters QL... xx
Nonvolatile parameters QR... xx
x Function not available in this software version
þ Function available in this software version
Function TNC 426/ TNC 430, software version TNC 410
280 476 280 474 280 472 280 470 280 462 286 060
CYCL CALL PAT þ xxxxþ
CYCL CALL POS xxxxxx
Cutting data tables (WMAT block) þþþxxx
Feed rate F in the CHF block þþþxxþ
Contour definition DECLARE CONTOUR xxxxxx
Tilting the working plane: PLANE xxxxxx
Positioning behavior of rotary axes
FUNCTION TCPM
xxxxxx
FK programming: FL P2X/FLT P2X þþþþþx
FK programming: FL P2Y/FLT P2Y þþþþþx
FK programming: FL RX/FLT RX þþþþþx
FK programming: FL RY/FLT RY þþþþþx
FK programming: FL RPR/FLT RPR þþþþþx
FK programming: FL RPA/FLT RPA þþþþþx
FK programming: FL RAN/FLT RAN þþþþþx
FK programming: FC LEN/FCT LEN þþþþþx
FK programming: FC AN/FCT AN þþþþþx