HEIDENHAIN TNC 151 Q - Page 102

Function
Axis standstill with M-S-function
Exceptions: Axis standstill takes place
with M-functions which are followed
by a programmed stop (such as
M 00, M 02 . ..) or with a STOP or
CYCL CALL-block.
Touch probe system probing speed
Touch probe system measuring distance
Switchover HEIDENHAIN dialogue
programming
IS0 (G-code)-programming
“Transfer blockwise”
ASCI l-characters for data input
“Transfer blockwise”
ASCI l-characters for data output
“Transfer blockwise”
ASCI l-characters for beginning and
end of heading block
“Transfer blockwise”
ASCI l-characters for transmission
correction or block reoetition
Data format and transmission stop
for data interface V.24 (RS-232-C)
Operating mode data interface
V.24 (W-232-C)
“Transfer blockwise”
ASCI l-character, data transmission end
Central tool memory
Graphics hard copy printout
Number of command characters for
setting the printer interface +
1 command character
Graphics hard copy printout
2 each of characters for
setting the printer interface
Graphics hard copy printout
Number of command characters
before each print line +
1 command character
Graphics hard copy printout
2 each of characters before
everv orint line
Movement supervision
Touch probe system : safety distance
above measuring point for automatic
probing
--
.Projection of graphics image in
3 planes
.Rotation of the coordinate system
in the workina olane
Activation and function of
the Vth axis
Parameter
No.
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
Entry values
..+4 f
if 4 is added to the above entry value, no
axis standstill with output of spindle speed
..+8 4 if 8 is added -to the above entry value, no
axis standstill with output of M-functions
80...3000[mm/min]
0 19999.999 . . . C mm 1
0 2 HEIDENHAIN-dialogue
1 2 IS0 (G-codes)-format
0 . . .65 535
0 . . .65 535
0 . . . 12 079
0.. .I2079
0 . . .255
0 4 “Standard data interface”
1 2 “Transfer blockwise”
0 12 079
. . .
0 g no central tool memory
I...99 z
central tool memory with number
of tool stores
0 . . .65 535
0 . . . 65 535
0 . ..65535
0 . . . 65 535
0.03... IOCVl
0 . . . 19 999.999 [mm]
0 c German standard
1 2 U.S. third angle projection
if 2 is added to the previous entry value, the coordi-
nate system is rotated by f 90’
0 2 Vth axis inactive
1 2 Vth axis serves for orientation of main
spindle, without position display
2 g as per entry value 1, however with position
display (display instead of the IVth axis)
102