For the customized macro “Bolt hole circle” in section 9.4, the following dialogues must be stored
within the EPROM.
Dialogue No. 0
BOLT HQLE CIRCLE
Dialogue No. 1
NUMBER OF HOLES
Dialogue No. 2
RADIUS
Dialogue No. 3
X-COORDINATE
Dialogue No. 4
Y-COORDINATE
Dialogue No. 5
SET-UP CLEARANCE
Dialogue No. 6
TOTAL HOLE DEPTH
Dialogue No. 7
FEED RATE
If the dialogues have not been stored within the EPROM, the following texts, which have been stored by
HEIDENHAIN in the standard PLC-EPROM, can be called-up.
0 User Cycl
1 Cycl parameter 1
2 Cycl parameter 2
to . . .
14 Cycle parameter 14
The cycle designation may comprise 14 characters and 32 characters for parameter designations.
9.6 Nesting of customized macros
Further macros can be called-up within a customized macro. A maximum of 4 nesting levels is possible.
9.7 Special function of program parameters
The tool radius of the last tool call is stored under variable parameter 0108. With this, the last tool radius
can be used for parameter calculation and comparison.
The variable parameter 0108 can therefore, not be defined by Q-DEF in the NC-program.
0108 contains exclusively the tool radius.
0110 for M-functions which were output last
1 = no M-function output
0 = MO38 output
1 = M04. output
2 = MO51 after MO3
3 = MO51 after MO4
Q113 mm/inch execution
Program parameter Q113 signifies whether .the program is written in mm or inch. This parameter is set
after pres’sing the
q
BM -key and selection of the program.
NR
Selected program has been programmed in mm: 0113 = 0
Selected Iprogram has been programmed in inch: Q113 = 1
Program Iparameter is used if Q-parameter programs are to be executed in both mm and inch modes.
Depending on parameter 0113, certain Q-parameters (e. g. the number of repetitions for conditional
jumps) can be converted for execution in inch.
1
91
I
To Next Page
Loading...
