9.1 Dialogue languages for customized macros
As with stalndard dialogues, customized macros can also be displayed in two languages.
The entry value for machine parameter MP 259 is added to the dialogue number of the original
language. The English text of the appropriate dialogue is stored under this dialogue number.
Language switchover
259
Difference between Q-numiber of dialogue
for customized macros
and corresponding translation
Selection -’ as to whether original or English dialogue - automaticaliy takes place s~imultaneously to
the selection of the plain language standard dialogue via machine parameter MP 92.
Example:
Dialogues fear customized macro “Bolt hole circle”
0 Bolt hole circle
1 Number of holes
2 . . .
10 Bolt hole circle
11 Number of holes
Entry value in MP 259: 10
9.2 Test of customized macros
Customized macros which are still stored within the NC-program memory can also be recalled via PGM-call.
For testing,, the operating mode “Single block” is also possible.
9.3 Repetition of customized macros
Program part repeats cannot be executed within customized macros which have been stored within the
EPROM.
Program part repeats can however, be simply programmed via Q-parameter functions (refer to the following
example “Bolt hole circle”).
88
To Next Page
Loading...
