HEIDENHAIN TNC 151 Q - Altering Machine Parameters

8.4.2 Alteration of machine parameters
Code number 95148
Select machine parameter mode via the code number and alter entry values according to the following
sequence:
input/Output diagram for non-erased parameter memory
Display:
MACHINE PARAMETER PROGRAMMING
MACHINE PARAMETER MPO ?
and complete parameter list
NO
NO
r
YES
Transfer data from control
Transfer data from storage
to storalge unit press q
unit to control press ENT
-
0
--I
I
1
YES
By pressing q , q or
Cl
“T”o select required parameter No.
t
Enter parameters
After termination of parameter entry
press D;
q
Machine parameter display
is cancelled.
75