26
4. View and edit the name, then press . View and edit the number
and press . Choose VIP and MELODY RINGER, then press .
NOTE: To save a number from Blocklist into Phonebook, it is not allowed
and shows DOUBLE NUM. If you decide to delete a number from Blocklist
and then save the number into Phonebook, please refer to Section 11.1.4.
todeletethenumberfromBlocklistrstly.
To save a existing name into Phonebook, it is not allowed and shows NAME
EXISTED. Use a new name to save the entry.
10.4. Delete an entry or the entire caller ID log
1. Long press ,thenifyouwanttodeletejustoneentry.
2. Press or to to choose the entry and press . Press to
choose DELETE, then press toconrm.
3. If you want to delete the entire caller ID log, long press , press ,
then press to choose DELETE ALL, then press toconrm.
11. CALL BLOCK
This telephone is built-in with Smart Call Block feature*. This feature will
help you avoid nuisance calls by only allowing some numbers to make your
phone ring. Default setting Smart Call Block in this telephone if OFF but you
can enable it via your phone settings.
*ThisfeaturerequiresasubcriptionofCallerLineIdenticationservicefrom
your network service provider. Charges may apply.
Follow below table to chose the Call Block mode you prefer
Setting Expectation
OFF Call Block function is Disabled.
This is the default mode.
ON Call Block function is set to Manual. Numbers registered
in the block list (up to 100 numbers) will not go through
and the phone will ring silently.
Numbers can be added to the list while the phone is
ringing and / or after a call.
CONTACTS In this automatic mode, any number not registered in
your phonebook will automatically be blocked and not
cause your phone to ring. All calls from contacts regis-
tered in your phonebook will proceed normally. When
this mode is chosen, Contacts OK is displayed on LCD in
idle mode unless you have missed call.
To Next Page
Loading...
