HelloBaby HB2688 - Telephone Base Settings; Register a Handset; Change the Dial Mode; Change the Flash Time

32
13. TELEPHONE BASE SETTINGS
BASE can be customized according to your preference by accessing
BS SETTINGS to select the settings.
1. Press to enter the menu.
2. Press or to select BS SETTINGS, press toconrm.
3. Press or to select DELETE HS/ DIAL MODE/ FLASH TIME/
CHANGE PIN/ ECO MODE/ AREA CODE then press toconrm
the selection.
13.1. De-register a Handset
To de-registered a handset from the Base, 4-digit PIN need to be enterd.
Repeat Step 1 to 3 of Section 13 to select DELETE HS, press , then
enter 4-digit system PIN, press .
• Press or to select one of the handset when need to be
de-registered, then press toconrm.
NOTE: If PIN correct, handset will go to next step. If PIN incorrect, handset
will go back to previous level.
13.2. Change the dial mode
• Repeat Step 1 to 3 of Section 13 to select DIAL MODE, press ,
press or to select TONE or PULSE, then press toconrm.
13.3. Change the Flash Time
TheashtimesettingsiscountrydependentandneedstocontactLocal
Service Provider for the correct settings.
• Repeat Step 1 to 3 of Section 13 to select FLASH TIME, press ,
press or to select SHORT or MEDIUM or LONG, then press
toconrm.
13.4. Change the system PIN Code
A 4-digit system PIN code needs for changing the system settings of the
base station. The default system PIN code is 0000.
• Repeat Step 1 to 3 of Section 13 to select CHANGE PIN, press ,
then needs to enter the existing 4-digit system PIN, then press to
conrm.
• Enter new system PIN code, then press .