18 NETLink
®
Ethernet Products
When installing the program on Windows 7 operating systems,
make sure to not only log in with the Administrator account, but
to also run the program setup file using the “Run as administra-
tor” option!
For more detailed information, please refer to the relevant NET-
Link Quick Start Guide.
4.3.1 Adding the interface to the PG/PC interface
After initial installation, the new interface parameter set ‘NET-
Link-S7-NET’ has to be set up. Administrator rights are necessary
for this.
Start the program module 'Set PG/PC Interface' with the Control
Panel of your Windows PC. When the 'Select...' button is dis-
played under Add/remove interfaces, click it.
This installation step is
not needed in Windows
7 operating systems. If
you are using a compu
t-
Windows 7,
please skip ahead to the
next section.
To Next Page
Loading...
