Helmholz NETLink 700-881-MPI21 - Setting TCP parameters

NETLink
®
Ethernet Products
29
If you do not want the name that is stored in the NETLink
®
to be
the same as the station name, you can overwrite the station name
(e.g. replacing the name ‘Helmholz_test’ with the name ‘Workshop’
in the example below).
This completes parameterization of the driver.
It may now be necessary to adapt the NETLink
®
Gateway to the
situation in the existing TCP/IP network.
5.2.2 Setting TCP parameters
To change the TCP parameters, select the station in question and
open the following dialog box with the ‘Edit’ button.
As a default, the S7-Net
driver attempts to address
the NETLINK® via the
fixed port 7777