NETLink
®
Ethernet Products
A: The following points should be observed when using a
NETLink
®
gateway:
- Access point in the PG / PC Interface "CP_L2_1" -> NETLink
®
USB / PRO Family
- "Automatic Baudrate": OFF (= Enable Single Master)
- set the timeout not higher than 20 seconds. (Otherwise the
MTC10 software takes a long time to see all the participants be-
cause it attempts to connect to each).
Q: I have installed the NETLink-S7-NET driver as described, but
receive error messages like the following in the TIA portal:
A: The necessary configuration of the NETLink
®
adapter always
takes place through the settings dialogue in the system control el-
ement "PG/PC Interface". To this purpose open "Set PG/PC Interface"
through the Windows Control Panel. The adapter-specific param-
eter can in this way also be changed at any time. At least the cor-
responding IP address and a name must be assigned in the
NETLink
®
setting dialogues.
Q: Is there a hidden button on the NETLink
®
housing to carry out
a factory reset?
A: The resetting of all parameters is only possible with the web
interface. To this purpose the http registration data are also re-
quired. With the 'Restore Factory Defaults' button it is then possible
to restore the delivery state of the NETLink
®
.
Q: What must I observe when calling your technical support?
A: Please have all relevant data of your system constellation with
the connected stations, program modules and status messages at
hand when you contact technical support from Helmholz GmbH
& Co.KG.
To Next Page
Loading...
