NETLink
®
Ethernet Products
11.3.3 Address conversion table
The following table is a parameterization aid for fining the correct
setting for Routing over RFC or for remote TSAP in addressed
mode. Please note that the rack and slot together fill only one
byte which is divided as follows:
• Rack fills the upper three bits (11100000
bin
)
• Slot fills the lower five bits (00011111
bin
)
-addr.
-addr.
-addr.
-addr.
4 0 4 0204 36 1 4 0224 68 2
4 0244 100 3 4 0264
6 0 6 0206 38 1 6 0226 70 2
6 0246 102 3 6 0266
8 0 8 0208 40 1 8 0228 72 2
8 0248 104 3 8 0268