Hemisphere GPS eDriveTC - Page 23

14
2: Getting Started
Install Valve Control Cable: -
1. Connect the valve
control cable
(supplied with the
model specific
installation kit) to
the eDriveTC
console.
2. Twist the
connector firmly
until it locks into
place.
Install Steering Wheel Switch Cable: -
1. Connect the
steering wheel
switch cable
(supplied with the
model specific
installation kit) to
the eDriveTC
console.
2. Twist the
connector firmly
until it locks into
place.
Valve Control Cable
Steering wheel switch cable
(refer to the steering wheel kit
instructions (part number
876-0082) to install the steering
switch cable)