Users Manual Henkovac 04-serie V2019
2.0 Table of Contents
1.0 Safety Regulations and Warnings 2
2.0 Table of Contents 3
3.0. Welcome 5
3.1 Service from your Dealer 5
3.2 YouTube Henkovac Channel - Instruction and Service Videos 5
3.3 General Precaution 5
4.0 Installation of Machine 6
4.1 Gas Connection for MAP Applications 6
4.2 Compressed Air Connection for Additional Sealing Pressure 6
5.0 Overview of Main Machine Components 7
6.0 Digital Control with LCD Display 8
6.1 One-Program Control System 8
6.2 Operating the Machine with One-Program Control System 9
6.3 Ten-Program Control System 10
6.3.1 Time-Based Operation 10
6.3.1.1 Option Sensor and option Soft-Air retrofit 10
6.3.2 Sensor-Based Operation 10
6.3.2.1 Option Soft-Air retrofit 10
6.4 Operating the Machine with Ten-Program Control System 11
7.0 Programming the Machine 13
7.1 One-Program Control System 13
7.1.1 Programmable Functions 13
7.1.2 Programming 13
7.1.3 Reviewing Function Values for P1 13
7.1.4 Adjusting the Vacuum Time for P1 13
7.1.5 Adjusting the Sealing Time for P1 13
7.1.6 Turning Off Machine 14
7.2 Ten-Program Control System 14
7.2.1 Programmable Functions 14
7.2.2 Reviewing Function Values for P1-P9 14
7.2.3 Programming adjusting Function Values for P1-P9 15
7.2.4 Turning Program Functions ON/OFF 15
7.2.5 Adjusting ON/OFF Functions 15
7.2.6 Turning Off Machine 15
8.0 Symbols in Display 16
9.0 Standard Vacuum Pump Settings: runs continuously or turns off end of cycle 18
9.1 One-Program Control System (stop cycle and aerate, or next step) 18
9.2 Ten-Program Control System (stop cycle and aerate, or next step) 18
10.0 Explanation terminology used 19
10.1 Sensor-Based Control 19
10.2 Time-Based Control 19
10.3 P H
2
O Program for Liquid Products 19
10.4 Vacuum Plus 19
10.5 MAP Gassing 19
10.6 Sealing 20
10.7 Extra Sealing Pressure 20
10.8 Soft-Air 21
10.9 Multi-Cycle 21
10.10 Cool-Down/Oil Dehumidification 21
To Next Page
Loading...
