What to do if Henny Penny Fryer operating pressure is too high?
If the operating pressure is too high, it could be that the deadweight is clogged. Turn off the fryer and allow it to cool to release the pressure in the frypot. Then, clean the deadweight. See the Preventive Maintenance Section for instructions.
What to do if Henny Penny PFE-590 Fryer pressure not exhausting at end of Cook Cycle?
If the pressure is not exhausting at the end of the cook cycle, it could be due to a clogged solenoid or exhaust line. Turn off the fryer and allow it to cool to release the pressure in the frypot. Have all lines, the solenoid, and the exhaust tank cleaned.
What to do if my Henny Penny Fryer shows 'E05'?
If the Henny Penny Fryer displays 'E05', it indicates the shortening is overheating. First, turn the switch OFF, then back ON. If the error persists, have the heating circuits and temperature probe checked. After the unit cools down, the controls should return to normal. If 'E05' continues, the controls may need replacement.
What to do if my Henny Penny PFE-590 Fryer shows 'E06'?
If the Henny Penny Fryer displays 'E06', it means there is a temperature probe failure. Turn the switch OFF and then back ON. Have the temperature probe checked, and repair or replace it. Once the temperature probe is repaired or replaced, the controls should return to normal. If 'E06' persists, the controls may need replacing.
What to do if my Henny Penny Fryer shows 'E04'?
If the Henny Penny Fryer displays 'E04', it indicates the control board is overheating. Turn the switch to the OFF position, then back to ON. If the display still shows 'E04', check for signs of overheating behind the control panel. Allow the panel to cool down, and the controls should return to normal. If 'E04' persists, the control may need to be replaced.
What to do if my Henny Penny PFE-590 Fryer shows 'E41'?
If the Henny Penny Fryer displays 'E41', it signals a programming failure. Try turning the switch OFF, then back ON. If the display continues to show 'E41', re-initialize the control (see programming section). If the error code persists, the control panel may need replacement.
General| Model | PFE-590 |
|---|---|
| Category | Fryer |
| Type | Pressure Fryer |
| Power Source | Electric |
| Temperature Range | 200°F - 400°F |
| Oil Capacity | 50 lbs |
| Voltage | 208/240V |
| Phase | 3 |
To Next Page
