8. Tips and tricks
8.1. Switching on all of the LEDs
Press the Loop In and Loop Out buttons on decks 1 and 2.
8.2. Switching on/switching off the 4 LEDs under the
controller’s feet
Press pads 1 and 5 on deck 1, along with pads 4 and 8 on deck 2.
8.3. In Serato DJ Lite
Changing the tempo scale (from 8% to 16% or 50%)
Press the Shift + Quant buttons.
Moving the tempo scale while maintaining the same precision
Enable Sync mode on the virtual deck, press the Shift button and move
the tempo fader: the software stops following the tempo fader’s
movement while the Shift button is held down, and resumes following its
direction of movement when the Shift button is released.
Example: switching from a tempo scale of -8% – +8% to +8% – +24%.
1) Enable Sync.
2) Move the tempo fader completely to the bottom (+8%).
3) Press the Shift button and move the tempo fader completely to
the top: the software remains at +8%.
4) Release the Shift button: the minimum position (at the very top)
gives you a tempo at +8%, while the maximum position (at the
very bottom) is at +24%.
To Next Page
Loading...
