Product Identification: Optima Laser Cutting and Engraving System
Manufacturer: Universal Laser Systems, Inc.
16008 N. 81
st
St.
Scottsdale, AZ 85260
USA
Universal Laser Systems, Inc. hereby declares that the equipment specified
below is in conformity with the following directives:
89/336/EEC (EMC Directive)
73/23/EEC (Low Voltage Directive)
89/392/EEC (Machinery Directive)
based on the standards listed.
Standards Used:
Safety:
EN 60950: 1995
EN 60825: 1994 (Class IIIa)
EMC:
EN 55022: 1995 (Class A)
EN 50082-1: 1992
EN 60801-2: 1993 (6kV CD, 8kV AD)
EN 61000-3-2: 1996 (class A)
EN 61000-3-3: 1995
EN 61000-4-3: 1997 (3 V/m)
EN 61000-4-4: 1995 (2 kV power line, 0.5 kV signal line)
EN 61000-4-5: 1996 (class 2)
Manufacturer’s Contact:
Chris Risser, Compliance Engineer
1998
Signature Date
Warning - This is a Class A product. In a domestic environment this
product may cause radio interference in which case the user may be
required to take adequate measures.
To Next Page
Loading...