COMMENTS: Unmasked. A low PPI setting is used to prevent flaming.
ADDITIONAL COMMENTS
Making a seal using plastic is revolutionizing the industry. The laser can engrave and cut out a
typical Notary Seal in less than 5 minutes. A male and female die must be made as the
diagram below indicates.
Seal Sample
Create the male with a white graphic and a black background. Mirror the image and invert it by
making the background white and the graphic black. Add a .010 inch black outline to the
graphic portion of the female side. This will give the greater clearance to the female side to
prevent the paper from piercing through when the male side of the seal presses into the female
side. Once the seal is made and fastened to the press, make several impressions onto 400 grit
sandpaper to smoothen out the edges of the plastic. Make sure you turn the sandpaper over to
get both sides of the seal.
To Next Page
Loading...