Installation 2-5
Unpacking and Assembling the System
Since packaging can change from time to time, please refer to the Unpacking and Assembly
Instructions found inside of the shipping container when you first opened it.
Computer Requirements
The following is our minimum recommended computer configuration. Using a faster computer
with more capacity will increase efficiency and throughput. Although using a computer that
does not meet our minimum recommendation might be acceptable to you, a faster computer
will definitely pay for itself in a short amount of time.
• Pentium 120 Mhz or equivalent
• 32 MB of RAM
• 2 Gigabyte hard drive or bigger
• 17 inch color VGA monitor
• 3.5” floppy disk drive
• CD-ROM Drive
• Mouse or other pointing device
• Microsoft Windows 95
• 600 DPI Optical Resolution Scanner
Remember, the laser system is an output device just like a printer is. The faster you can create
graphics and manipulate your software, the faster you can download to the laser system to
keep it producing.
Software Suggestions
The following is a list of recommended software programs. We do not endorse any particular
software program neither do we guarantee it’s full compatibility with the laser system. Please
refer to the Appendices section on known bugs/anomalies related to these particular software
programs, related versions, and ones that are not listed below.
Graphics Programs
• CorelDraw
• Macromedia Freehand
Bitmap / Scanning Software
• Adobe Photoshop
• Adobe Streamline - for raster to vector conversion
To Next Page
Loading...