EasyManua.ls Logo

HERO Passion Xpro - RIDING; BRAKING

HERO Passion Xpro
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Running in
If the engine fails to start after repeated
attempts, it may be flooded with excess fuel. To
clear a flooded engine, turn the ignition switch
“OFF” ( ) and turn the choke lever to “OFF”.
Close the throttle fully and crank the engine
several times with the kick starter. Turn the
ignition switch “ON” ( ) and start the engine
without using choke.
RIDING
Flooded engine
During first 1000 km, do not operate the
vehicle at more than 60 km/hr speed in top
gear, 45 km/hr in third gear, 30 km/hr in
second gear and 15 km/hr in first gear.
Avoid full throttle operation.
During initial running in, newly machined
surfaces will be in contact with each other and
these surfaces will wear in quickly. Running in
precautions till 1000 km will reduce initial
wear of engine components and increase its
service life.
•
After the engine has been warmed up, the
vehicle is ready for riding.
•
While the engine is idling, press the clutch
lever and depress the gearshift pedal to shift
st
into 1 (low) gear.
•
Slowly release the clutch lever and at the
same time, gradually increase engine speed
by opening the throttle. Coordination of the
throttle and clutch lever will assure a smooth
positive start.
•
When the vehicle attains a moderate speed, close
nd
the throttle, press the clutch lever and shift to
2
gear by depressing the gearshift pedal.
•
The sequence is repeated progressively to
rd
th
shift 3 and 4 (top gear).
Recommended max. operating speed in
each gear.
st rd
1 20 km/hr 3 70 km/hr
nd
th
2 45 km/hr 4 100 km/hr
CAUTION
!!
Do not shift gears without operation of clutch
and without closing the throttle otherwise this
would lead to damage of gears.
23
•
For sudden deceleration/quick stopping,
close the throttle and apply the front and
rear brakes simultaneously.
To stop the vehicle, press the rear brake pedal
for the application of front and rear brakes
simultaneously. However, for more effective
braking, it is advised to apply front and rear
brake simultaneously, keeping the throttle in
closed position.
BRAKING
•
For normal braking, close the throttle and
gradually apply both front and rear brakes
simultaneously while shifting down gears to
suit your road speed.
For integrated braking system (IBS)
1
2
3
4
N