HERO Passion Xpro - Drive Chain Slider Inspection; Brakes

41
•
Lubricate the drive chain by applying liberal
amount of SAE#90 oil.
CAUTION
!!
Regular adjustment and lubrication as per the
maintenance schedule would ensure high
performance and longer life.
(Refer to “Maintenance Schedule” on
(page 27).
DRIVE CHAIN SLIDER INSPECTION
Check the drive chain slider (1) for wear, the
chain slider must be replaced if it is worn to the
bottom of the cutout or wear limit (2) is
reached. For replacement, visit your
Authorised Hero MotoCorp workshop.
NOTE
for inspection, cleaning, lubrication and
Visit Authorised Hero MotoCorp workshop
adjustment of drive chain at every 2000 km.
(1) Drive chain slider (2) Wear limit
CUTOUT
2
1
BRAKES
(Disc type)
When one applies the Integrated/Rear brake
pedal, front & rear brakes activate jointly.
Brakes (Integrated braking system)
Brakes are items of personal safety and should
always be maintained with proper
adjustments.
Brake fluid recommended: DoT 3 or DoT 4
Fluid level-Ensure that the brake fluid level
does not fall below “MIN” mark (1) on the
master cylinder, when checked with the
master cylinder parallel to the ground. The
level decreases gradually due to piston
the brake system and contact your Authorised
Hero MotoCorp workshop.
movement to compensate pad wear. If the
level decreases abruptly, check for leakage in
(a) Front brake inspection (Disc type)
Master Cylinder/Reservoir.
Location: Right handle bar.
1
(1) "MIN" mark