14
NOTE
Ÿ If the battery voltage is low, the i3s system
will not work. The i3s indicator on the
speedometer console will start to blink, if the
rpm is less than 2000 rpm and the i3s
indicator goes off if the rpm is more than
2000 rpm. The vehicle will be in normal
operating conditions as other vehicles and
no special functions will be performed.
Ÿ If the vehicle is driven without battery or
with the dead battery, the i3s system will not
work. The i3s indicator on the speedometer
console will start to glow continuously. The
vehicle will be in normal operating
conditions as other vehicles and no special
functions will be performed.
Ÿ During electric or clutch start, the engine
will cut-off
Ÿ if engine reaches 900 rpm
Ÿ if the relay is engaged for more than 5
seconds.
Initial Activation of the i3s system:
Keep the i3s switch (1) to “ON” position.
Turn the Ignition key to “ON” position. The
i3s indicator (2) on the speedometer console
will glow for 2 seconds and turn “OFF”. Start
the vehicle and allow the engine to run in
neutral gear position with the rpm less than
2000 rpm. The engine will cut off in 30 secs.
After the rst stop start every subsequent stop fi
will be in 5 secs.
In this condition, the engine can be restarted
either with kick or electric start only.
Driving with i3s Switch in “ON”
position:
While driving, if the engine is kept idling (while
waiting in a traf c signal), the engine will cut fi
off in 5 secs. (The vehicle should be in neutral
less then 2000 rpm with clutch lever/throttle
is in released position) By pressing the clutch
lever, the engine will start again and gear can
be engaged to move the vehicle.
Driving with i3s Switch in “OFF”
position:
While driving in a traffic jam/or very dense
traffic where the vehicle has to encounter a
stop and go situation, the i3s switch can be
changed to “OFF” position. Once this is done,
NOTE
Ÿ The engine will stall if the i3s switch is in
“ON” position during warmup.
Ÿ Use choke during cold conditions.
the i3s system will not work and the vehicle
will be in normal operating conditions as other
vehicles and no special functions will be
performed.
SIDE STAND INDICATOR/SWITCH
For the safety of the customer a side stand
indicator (1) is provided.
When the vehicle is parked on side stand
(Ignition Switch “ON”), an indicator lamp
glows in the speedometer panel.
To Next Page
Loading...
