4.2
Settings
1.
Reset All Settings
By clicking the “Reset All Settings” button on the top-right corner,
all configurable parameters in the Settings page and the Azimuth
FOV page will be reset to their default values.
The default values are shown in the left-hand screenshot and in
Section 4.3.1.
2.
Control IP – VLAN
VLAN Tagging can be used when the receiving host also supports
VLAN function.
▪
Checkthe VLAN checkbox andinput a VLAN ID (range: 1~4094)
for the LiDAR unit.
▪
Set the VLAN ID of the receiving host to be the same.
3.
Settings – Destination IP
239.0.0.0~239.255.255.255
Same as the PC’s IP address
To Next Page
Loading...
