Hettich EBA 20 C - Symbol Meanings; Delivery Checklist

8/16
• Carbon brush change must be carried out by authorised and qualified personnel.
• The following safety regulations apply:
EN / IEC 61010-1 and EN / IEC 61010-2-020 as well as their national deviations..
• The safe operation and reliability of the centrifuge can only be guaranteed if:
− the centrifuge is operated in accordance with the operating instructions,
− the electrical installation on the site where the centrifuge is installed conforms to the demands of EN / IEC
stipulations.
− the tests for device safety required in the respective countries, e.g. in Germany in acc. with BGV A1 and
BGR 500, are carried out by an expert.
5 Symbol meanings
Symbol on the device:
Attention, general hazard area.
Before using the device, make sure you read the operating instructions and observe the safety
information!
Symbol in this document:
Attention, general hazard area.
This symbol refers to safety relevant warnings and indicates possibly dangerous situations.
The non-adherence to these warnings can lead to material damage and injury to personal.
Symbol on the device and in this document:
Beware of biohazard.
Symbol on the device:
Equipotential: Connector (PE connector) for potential equalization (only for centrifuge with PE
connector).
Symbol in this document:
This symbol refers to important circumstances.
Symbol on the device and in this document:
Symbol for the separate collection of electric and electronic devices according to the guideline
2002/96/EG (WEEE). The device belongs to Group 8 (medical devices).
Applies in the countries of the European Union, as well as in Norway and Switzerland.
6 Delivery checklist
The following items and accessories are delivered with the centrifuge:
1 Connecting cable
2 Fuses
1 Notes on moving the equipment safely
1 Operating instructions
1 Counter-weight (is required for centrifugation of an individual cell separation container)
2 Carbon brushes
Carbon brush change must be carried out by authorised and qualified personnel.
The model EBA 20 C is supplied complete with angle-rotor (2-times).