Hettich UNIVERSAL 320 - Machine Menu; Querying System Information; Querying Operating Hours

AB1401en_SARev.: 04 / 11.2023
34 / 44
Software operation
Parameter query
4. Press the [START/IMPULS] button.
🡆 The setting is stored.
‘*** ok ***’ is displayed briey.
5. Press the [STOP/OPEN] button twice or wait 8 seconds to exit the
menu.
7.5 Machine Menu
7.5.1 Querying system information
The rotor is stationary.
1. Press and hold the [SELECT] button for 8 seconds.
🡆 ‘SOUND/BELL’ is displayed.
2. Press the [SELECT] button repeatedly until ‘FU/CCI – S.’ is displayed.
Program version for the frequency inverter
3. Press the [SELECT] button repeatedly until ‘HOURS’ is displayed.
Internal operating hours (the time during which the centrifuge was
switched on)
4.
Turn to the right with the [Rotary knob] .
🡆 ‘STARTS’ is displayed.
Number of centrifugation runs
5. Turn to the right with the [Rotary knob] .
🡆 ‘ROTORCHG1’ is displayed.
Internal operating hour of the last rotor change
6. Turn to the right with the [Rotary knob] .
🡆 ‘ROTORCHG2’ is displayed.
Internal operating hour of the penultimate rotor change
7. Turn to the right with the [Rotary knob] .
🡆 ‘OPhoursCHG’ is displayed.
Internal operating hour of the last operating hours change
8. Turn to the right with the [Rotary knob] .
🡆 ‘IMBALCHG’ is displayed.
Internal operating hour of the last imbalance cut-off change
9. Turn to the right with the [Rotary knob] .
🡆 ‘OffsetCHG’ is displayed.
Internal operating hour of the last offset adjustment
10. Press the STOP/OPEN button to exit the menu.
7.5.2 Querying operating hours
The rotor is stationary.
1. Press and hold the [SELECT] button.
🡆 ‘SOUND/BELL’ is displayed after 8 seconds.
2. Press the [SELECT] button repeatedly until ‘CONTROL:’ is displayed.
🡆 ‘CONTROL:’ and the operating hours are displayed.
3. Press the [STOP/OPEN] button to exit the menu.