DC2000 – Installation Manual 11
HHO Plus, Alternative Energies, Lta – Travessa das Serras 33, Vieira de Leiria, Portugal – Tel. 00351244697116 – Email: info@hhhoplusgas.com
HHO injection point
The system is operated by vacuum suction from your car's air intake which takes the HHO directly to the
combustion chamber mixing it with the air/fuel. The injection point must be done right after the air filter box
and, in modern cars, after the MAF/MAP sensor (air flow sensor) and before the Turbo. Never make the
injection point after the Turbo or Intercooler because the pressure will not allow the best results with the
HHO system.
You will need to remove the air duct, to ensure that you do not leave any residue from the drilling you are
about to do. Drill an 8 mm hole close to the intake manifold. Clean out any drill shavings, insert the high
pressure fitting using goop glue or teflon tape and tighten. Connect the high pressure hose.
To Next Page
Loading...