Hi Sharp ATR620H - Page 23

23
3.6.2 Network stream
Step1: enter into system configurationnetwork configurationsub stream; refer to Fig 3-26:
Fig 3-26 network configuration-sub stream
Step2: select fps, resolution, quality, encode and max bit rate
Step3: user can setup all channels with same parameters, tick off “all”, then to do relevant setup.
Step4: click “default” button to resort default setting; click “apply” button to save the setting; click “exit” button
to exit current interface.
Definitions and descriptions of network stream:
Parameter
Meaning
Signal TVI/AHD / 960H IP
FPS
1-30（NTSC）/1-25(PAL) 1-30（NTSC）/1-25(PAL)
Resolution
CIF
CIF、D1
Quality
The quality of the clients’ image. The higher the value is, the clearer the record
image.
Six options: lowest, lower, low, medium, higher and highest.
Encode
VBR and CBR.
Max bitrate
Range from: 32~768 kbps Range from: 32~768 kbps