Hi-Target V30 Plus - Indicator Lamp; Static Survey

V30 Plus GNSS System User Manual
8
2.2.2 Indicator Lamp
Table 2-2-3 Description of Indicator Lamp Function
Item
Status
Description
Power Light
(Yellow)
Long-term
Lighting
In Normal Voltage Battery Remaining≥60%
Power Lamp (Red)
Always On
Battery Remaining: 10% ~ 60%
Slow Flash
Low Voltage: Battery Remaining < 10%
Signal Lamp
(Green)
Off
No GSM Connection
Always On
GSM Module Connect to Server Successfully
Slow Flash
Host is Connecting to Server
Data Lamp (Red)
Flash
The data link sends and receives data (The rover station only
prompts to receive, and the base station only prompts to transmit)
Static acquisition flashes at sampling frequency (More than 1Hz
flashes according to flash frequency "200ms"), in this status static
data has been collected.
Satellite Lamp
(Green)
Always On
Satellites tracked successfully
Slow Flash
Lose satellites and try re-track
Satellite Lamp
(Red)
Fast Flash
The motherboard is abnormal, the green light is off.
Flash
In temporary static mode, flash according to the sampling interval.
Long-term Lighting
Reset Main Board or Static Collecting
Error (Insufficient Storage Space)
Anomaly flash of 3 lamps
2.3 Static Survey
V30 Plus receiver can be used for static measurement. It is set by double-clicking the
power key to enter the mode switching, every double-clicking, switching one mode of
operation. In the mode switching process, click the power key to confirm, the red state light
flashes every few seconds (according to the sampling interval) and then collects one