VertX V1000 (CS) Quick Installation Guide
Note: Most configurations will not Advanced Setup require accessing the screen.
3 .1 .2 .1 Stat ic N etw ork
Configuration If using a Static TCP/IP network, proceed with changes using the information collected on the
Checklist, page 18.
3 .1 .2 .2 DH CP Ne tw ork
If using a DHCP TCP/IP network, this information is configured automatically.
3 .1 .2 .3 Modem
Configuration ChecklistIf using a Modem, proceed with changes using the information collected on the .
3 .1 .3 Basic Cent ral St ation / H ost Com m unication Set up
Enter the CS/Host IP Address Host Name Here I Am Interval or , and the collected on the Configuration
Checklist, page 18. See central station automation software, page 16.
3 .1 .3 .1 Controller Login Passw ord
During your first instance of accessing the Configuration GUI, you must change the password (located at the
bottom of the screen). Enter a new password, and reenter the password in the second field.
Note: This step is not necessary during any consecutive Configuration GUI sessions. However on consecutive
sessions the password may be changed.
Submit, and the Confirmation page (see 3.1.4
Once configuration changes have been made, click
Confirmation, page 13) will display.
3 .1 .4 Confirm a tion
ConfirmationOnce configuration changes are complete and submitted, the screen will display. Verify that the
changes submitted are accurate, and click
Save Cancel. If the changes submitted are not accurate, click and
adjust the settings appropriately.
October 2006 Page 13 of 20
© 2006 HID Global Corporation. All rights reserved.
To Next Page
Loading...
