15 - 60
2.6.12 Display mounted on board
Only in combination with the DVS version, the machine has a dedicated front panel that houses the unit's display.
2.6.13 Upwards supply rectangular flange kit
Only in combination with the DVS version, the machine mounts a dedicated panel that directs the supply air upwards.
2.6.14 Rear supply rectangular flange kit
Only in combination with the DVS version, the machine mounts a dedicated panel that directs the supply air behind the machine.
2.6.15 Display remoting cable (5, 10 or 20 m)
A shielded 2-wire cable with a length of 5, 10 or 20 meters is provided, already ready and adjusted for connection between the
machine and the wall display, it is only available for DVS and DOS units.
2.6.16 Remote display with connection cable (2 m)
The display is supplied and a 2-meter shielded 2-meter long cable ready for use between the machine and the wall display is
available only for the DVS and DOS units.
2.6.17 High efficiency filter
A filter is installed that is more efficient than the one already present in the unit, which increases the cleanliness of the air and
retains the dust particles arriving from the outside more effectively.
2.6.18 Circular channel supply flange kit
A flange allows ducting of the delivery of the unit with spiral hoses, for the 70, 90 and 100 units the flange will mount a 250 mm
opening, for the 160, 190, 210 and 230 units it will mount two 250 mm openings. It is only available for the DOS units.
2.6.19 Circular channel return flange kit
A flange is used to channel the return of the unit with spiral hoses, for the 70, 90 and 100 units the flange will mount a 250 mm
opening, for the 160, 190, 210 and 230 units it will mount two 250 mm openings. It is only available for the DOS units.
2.7 INSTALLATION
The DDS, DVS and DOS units are designed for installation directly in the room to be dehumidified.
The DCS units are designed for installation in a technical room adjacent to the room to be dehumidified and are supplied
without the front cover (see dimensional drawings).
The DCS units are designed for connection to plenums, supply and return air ducts and grilles (optional), or to other types of
ducts that allow extraction and delivery of the air from and into the room to be dehumidified.
2.8 ELECTRIC CIRCUITS
The electric panel is built and wired in accordance with standard EN 60204-1.
All the remote controls are implemented with low voltage signals, powered by an isolation transformer.
Do not disconnect the unit by removing voltage through the protection upstream of the unit; this
device must be used to disconnect the entire maintenance unit. To switch off temporarily act on
the user terminal.
To Next Page
Loading...
