46 - 60
7.5.2 Installer parameter configuration
The installer parameters allow you to modify some of the advanced settings of the unit.
Some parameters significantly change the operation of the unit.
ONLY MODIFY IF NECESSARY
To access the installer menu, follow these steps:
- go to the main page by pressing the EXIT button if necessary
- press the MENU button to access the first page of the user menu
- scroll with the DOWN key to the last page (page 9)
- press the OK key
- the password is requested, enter "0010" and confirm with the OK button
Use of keys:
- With UP and DOWN you slide from one screen to another (some screens do not always appear)
- With EXIT you exit and enter the main screen
- with OK you execute the function indicated on the screen
Some screens may be not always present
It is used to change the fan speed in the operating phases:
1. in recirculation it is possible to set MINIMUM, MEDIUM or MAXIMUM
2. in dehumidification it is possible to set MEDIUM or MAXIMUM
default: minimum recirculation and average dehumidification
It is used to change the timer that indicates filter cleaning
Setting 120 days the need to clean the filters is reported on the main page every 4 months
default: it is signalled every 120 days
It is used to modify the differentials that regulate the dehumidification request
default: differential on 3% and off -3%
It is used to change the differentials that regulate the heating request
This page is only present if the hot water coil option with valve or the electric resistance option
has been purchased.
default: differential on -0.5°C and off 0.5°C
To Next Page
Loading...
