13 - 60
2.5 FUNCTIONS
The DDS, DCS, DVS and DOS units are equipped with a powerful control with graphic display and
on-board temperature and humidity probes that make the dehumidifier completely autonomous
in reading and managing temperature and humidity.
The control consists of a card with programmable microprocessor and a graphic display that
allows a large number of functions and options that can be easily managed thanks to a simple,
complete and intuitive interface.
The dehumidifier management software is entirely developed in the company by highly specialist
technicians. The Control display can be remoted up to 20m away and, thanks to the temperature and humidity probe on the
machine, it can manage temperature, humidity and machine stand-by time bands.
Personalised software is available on request in special version.
Below are all the control functions:
- Display of unit operating status and/or alarms
- Temperature and humidity probe on the machine
- Low evaporation pressure protection probe
- Management of 3 ventilation speeds in dehumidification, recirculation and heating
- Stand-by time band management
- Time slot temperature management
- Time slot humidity management
- Alarm history management
- Simultaneous management of electric heating elements and hot water coil with 3-way valve (models 040 - 050 - 060
excluded)
- Automatic static defrost management
- Automatic hot gas defrost management
- Digital output for generic alarm
- Backlit graphic display
- Possibility to remote the display for a wall positioning
2.6 OPTIONS
To Next Page
Loading...
