Higen FDA7015 User Manual

3. Parameter setting
3-50
ALS-02
Alarm Reset
Unit
-
Setting range
ON/OFF
Manufactured
default
OFF
Speed/Torque/
Position control
It resets and initializes the occurred alarm. Check and remove the cause of the alarm before
resetting the alarm and then reset.
This is the parameter that the occurrend alarm history resets and initializes.
ALS-03
~
ALS-12
Alarm History 1
~
Alarm History 10
Unit
-
Indicated range
0 ~ 32
Manufactured
default
0
Speed/Torque/
Position control
This is the menu that stores and shows the alarm history. The user cannot set this arbitrarily.
ALS-13
History Reset
Unit
-
Setting range
ON/OFF
Manufactured
default
OFF
Speed/Torque/
Position control
It resets and initializes the occurred alarm history.

Higen FDA7015 Specifications

General

Output Power	1.5kW
Rated Current	7A
Output Current	7A
Control Mode	Torque, Speed, Position
Communication Interface	RS485
Protection Features	Overvoltage, Undervoltage, Overcurrent, Overtemperature, Short Circuit